- 1-4 or 16 channels
- 1-4 data bits per channel (4 channel), 1 clock and 1 data bit per channel (16 channel)
- ECL compatible driver/receivers
- Transfer rates up to 60 Megabits per second per channel
- Implements a high-speed DMA channel between an external device and PCIBus computer
- Customized by a Ram based programmable gate array
- Single short PCIBus slot
- Low cost
The PCI GP-ECL board samples the data on the rising edge of the clock and stores it in host memory by the PCI GP-ECL DMA. It provides a simple, flexible low cost solution for Telemetry, Satellite and Monitoring applications.
In SSD4 mode, the PCI-GP-ECL provides a synchronous serial interface that can collect one to four channels and one to four data bits of synchronous serial data per channel. Transfer rates are up to 60 Megabits/sec.
- Telemetry Receiver
- Monitoring Serial Data Communications
- Satellite Ground Station Support
Device drivers for Solaris™ (Sparc & Intel platform), Windowstm, and Linux are included with the PCI GP-ECL. The driver provides access to the PCI GP-ECL through standard and asynchronous read and write system calls. A DMA ring buffer management library is provided for high speed continuous transfers.
Custom cable assemblies suited to your application can be provided. click here for a list of standard EDT cable assemblies.
EDT provides several levels of customer support, from phone consultation to custom design of hardware and software, at hourly rates.
PCI Local Bus Compliance
PCI 2.1s
33Mhz
32 bits
Data Transfer Protocol: synchronous
Transfer 1, 2, or 4 separate
Signals
Standard ECL signal levels, terminated through 50 ohms to -2 volts.
Connector
Power
Environmental
Physical
To order, contact our sales department or your distributor. Be sure to specify which cable will be needed (if any).
All Trademarks referenced are the service mark, trademark, or registered trademark of the respective manufacture
|
